11/8/2023 0 Comments Matlab hdl coder examples![]() In MATLAB, create a new HDL Coder project by selecting HDL Coder from the Apps menu.With the modified function and test bench, you can now create the HDL Coder export, which involves creating an HDL Coder project, determining a fixed-point representation for the function, then configuring the HDL generation parameters. To verify that the function stills runs as intended, run the test bench from the Command Window and confirm that the output matches the image below.Note that valid_in is given a constant value of 1. Update the test bench call to the function being tested to include the new inputs and outputs.In the test bench, add declarations for new output variables to contain the Valid Out signals.Now that the function has been modified, the corresponding test bench should be updated as well.If cycles of invalid data will occur between cycles of valid data, NI recommends using handshaking such as AXI in the top-level interface. Note: This method of handling the valid signals assumes that once valid data is given to the filter, every subsequent cycle valid input is available until the filtering is complete. For the x_valid_out variable, the structure should mimic the existing delay lines for the delayed_xout variable. For the valid_out and valid_signal variables, this is as simple as treating the valid_signal variable as a temporary variable between the valid_in and valid_out parameters. ![]() To accomplish this, add another chain of delay registers: The x_valid_out signal should receive the same amount of delay as the delayed_xout variable. Since the function and test bench assume that y_out is valid after any call of the function, no persistent variable is needed.ī. The valid_out signal should update at the same point that y_out becomes a valid value.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |